The object of the research is the process of directed structure formation in the body of alkaline concrete, made using a reactive aggregate, in this case, basalt, and the process of deformation development in such concrete. The problem with using reactive aggregates is that they cause alkaline corrosion. It manifests itself in the form of cracks and layers of gel-like substances that form at the point of contact of the aggregate with the cement stone. During the research, methods of physical and chemical analysis were used (X-ray phase, differential thermal and thermogravimetric analyzes, electron microscopy, infrared spectroscopy, microprobe analysis). And also methods of mathematical planning of experiments have been used for the dependence of the physical and technical properties of cements and the directions of their structure formation. Also, the research has been carried out based on the analysis of world achievements in solving the problem of alkaline corrosion of concrete. The possibility of joint operation of the matrix of alkaline cements and active aggregates, represented by basalt, has been determined. The component composition of alkaline cement has been optimized and the need to increase the amount of the alkaline component in the system for the normal course of structure formation processes has been proved. The study of the influence of technical factors and conditions of hardening on the development of processes of structure formation of the investigated compositions has been carried out. The deformation properties of fine-grained concrete based on slag-alkaline cement and basalt aggregate have been investigated. It is shown that the expansion deformations of the samples, which accompany the process of alkaline corrosion of the aggregate in concrete, are directly related to the component composition and hardening conditions of the material. The obtained research results confirm the possibility of using active aggregates for the manufacture of building materials, in particular, based on alkaline cements. But for the safe course of the processes of structure formation, the component composition of the system has to be adjusted by introducing an active mineral additive and an additional alkaline component. The use of hydrophobizing additives makes it possible to increase the strength of the material even when operating under normal heat and humidity conditions.